Epson PowerLite EB-810E - Solutions When an Afterimage Remains on the Projected Image; Solutions to Sound Problems

289
• Position the projector close enough to the screen.
• Make sure you have run the Light Source Calibration in the Management menu recently. If using
multiple projectors, perform the calibration on all projectors to ensure a consistent image quality.
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal I/O Menu
Administration Settings - Management Menu
Image Quality Settings - Image Menu
Solutions When an Afterimage Remains On the Projected Image
If you see an afterimage in the projected image, select Refresh Mode > Start in the Management menu.
Parent topic: Solving Image or Sound Problems
Related references
Administration Settings - Management Menu
Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
• Adjust the projector's volume settings.
• Press the A/V Mute button on the remote control to resume video and audio if they were temporarily
stopped.
• Check your computer or video source to make sure the volume is turned up and the audio output is set
for the correct source.
• Check the cable connection between the projector and your video source.
• If you do not hear sound from an HDMI source, set the connected device to PCM output.
• If you are using the USB Display function, turn on the Output audio from the projector setting in the
Epson USB Display Settings program on your computer.
• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac
supports audio through the HDMI port. If not, you need to connect an audio cable.
• If you want to use a connected audio source when the projector isn't projecting any images, set the
Quick Startup option in the Operation menu to Off and make sure the A/V Output setting in the
Signal I/O menu is set to Always On.