195
2. Press the Menu button, select the Management menu, and press Enter.
3. Select the User's Logo setting and press Enter.
4. Select Start Setting and press Enter.
You see a prompt asking if you want to use the displayed image as a user's logo.
5. Select Yes and press Enter.
Note: Depending on the image signal, the screen size may change to match the resolution of the
image signal.
6. Make sure the image appears as you want it, then select Yes again and press Enter.
You see a completion message.
7. Press Esc to exit the message screen.
8. Select the Display menu and press Enter.
9. Select when you want to display the User's Logo screen:
• To display it whenever there is no input signal, select No-Signal Screen and set it to Logo.
To Next Page
Loading...
