220
Input Source Settings
To change settings for an input source, make sure the source is connected and select that source.
Note: You can restore the default settings of the Tracking, Sync, and Position settings by pressing the
Auto button on the remote control when connected to a Computer port on the projector.
Setting Options Description
Source — Displays the current input source
selected
Aspect See the list of available aspect
ratios
Sets the aspect ratio (width-to-
height ratio)
Turn off the Scale setting or set the
Scale Mode setting to Full Display
before selecting this setting. Setting
is only displayed when the current
source is HDMI, HDBaseT, or USB
and document camera.
Reset to Defaults — Resets all settings for the currently
selected input source
Scale Varying levels available When using multiple projectors to
project one image, adjusts the scale
of the image displayed by each
projector
Reset Image Settings — Resets all adjustment values on the
Image menu to their default settings
Note: Select Reset Image Settings to reset all settings on the Image menu to their default values.
Parent topic: Adjusting the Menu Settings
To Next Page
Loading...
