63
Setting Options Description
EAP Method EAP Type
User name
Password
Client Certificate
Verify Server Certificate
CA certificate
RADIUS Server Name
Sets the EAP settings for WPA3-
EAP and WPA2/WPA3-EAP
security
IP Settings DHCP (On or Off)
IP Address
Subnet Mask
Gateway Address
Selects DHCP if your network
assigns IP addresses
automatically, or turns off DHCP
so you can enter the network's IP
address, subnet mask, and
gateway address as needed
DNS Server 1/ DNS Server 2 Various IP addresses Sets the IP address for the DNS
server using 0 to 255 for each
address field. The DNS server
resolves the host name
Note: Do not use 127.x.x.x
(where x is a number from 0 to
255). When these settings are
not set and remain as 0.0.0.0,
DNS server information is
acquired using DHCP. After
acquiring the information, the
values remain as 0.0.0.0.
IPv6 On
Off
Enables IPv6 to allow monitoring
and control of the projector over
a network using Epson Web
Control and PJLink
Auto Configuration On
Off
Selects whether to automatically
assign addresses according to
the Router Advertisement
To Next Page
Loading...
