Vertical Form Handling
The printer is always equipped with two continuous form tractors. The last sheet
of a continuous form stack can be printed on up to the end of the form.
The capabillity of the printer to feed paper from different sources is optimally
supplemented by the option that automatically adjust the distance between the
print head and the print bar.
Table 4: Vertical Form Handling
Escape Sequence Mnemonic Function
ESC 0 Set Line Space to / "
1
8
ESC 2 Set Line Space to / "
1
6
ESC 3 P1 Set Line Space to / " (P1 =0/ 0...F/F)
P1
180
ESC + P1 Set Line Space to / " (P1 = 0/0...F/F)
P1
360
ESC A P1 Set Line Space to / " (P1 = 0/0...7/F)
P1
60
ESC B NUL Clear Vertical Tabs
ESC B P1 P2 . . . P16 NUL Set Vertical Tabs (P1...P16 = 0/1...F/F)
ESC C P1 Set Form Length in Lines (P1 = 0/1...7/F)
ESC C NUL P1 Set Form Length in Inches (P1 = 0/1...1/6)
ESC J P1 Perform / " Line Feed (P1 = 0/0...F/F)
P1
180
ESC N P1 Set Automatic Perforation Skip
P1 is the number of lines from bottom of
paper to skip. (P1 = 0/1...7/F)
ESC O Cancel Automatic Perforation Skip
ESC b P1 P2 .. P16 NUL Set Vertical Tabs in Channel P1
P1 = 0/0 .. 0/7 : channel 0 - 7
P2..P16 = line number (P2..P16 = 0/1..F/F)
To Next Page