Description of the Individual Menu Items
causes the paper to move to the tear off
position when the print job has been completed by a form feed command
and no new print job has been received within one second. If the paper is
not torn off and new printing data are received the paper moves back into
the printer and printing is continued at the first line of the following page.
, the printer will always cut the paper
when a switch from one tractor to the other has been initiated.
causes the form to be cut if no further printing data
have been received within a print job for a period of 10 seconds. After
cutting, the paper moves immediately into the top of form position of the next
page. This setting supports applications lacking a programmed form feed
after completion of a print job.
causes the form to be cut if, after a
, no further printing data have been received within a print job for
a period of 1 second. After cutting, the paper moves immediately into the top
of form position of the next page.
has the same function as CUT 1 S but is
independent of receiving of a form feed command.
the printer will cut continuous forms into
single sheets and feed them to the rear.
The application has to control page length. The page length must be
at least three inch, otherwise the printer is unable to through out the
To Next Page
Loading...
Need help?
General