185
Matching the Screens Automatically
Matching the Screens Manually
Parent topic: Using Multiple Projectors
Related tasks
Saving a Scheduled Event
Matching the Screens Automatically
You can automatically correct the brightness and tint for multiple projectors based on the brightness and
tint settings you selected for the master projector.
Before you start, make sure of the following:
• Select Multi-Projection for the Color Mode setting and adjust the Brightness, Contrast, Color
Saturation, Tint, White Balance, and Advanced settings in the Image menu, as necessary, on the
master projector.
• You are projecting on a matte white diffusion screen that is flat and even.
• The projected image is between 100 to 300 inches (254 to 762 cm) and is rectangular after tiling.
• All the projectors are connected to a network and the Location Setup setting has been configured.
• Nothing is blocking the built-in camera on the front of each projector.
• The projected images do not overlap or have gaps between them.
• The projectors are installed parallel to the screen.
• The Blend Range setting is set between 15 to 45%.
• All the projectors are the same model.
Note: Auto adjustment is not available for the following lenses: ELPLX02, ELPLX02W, ELPLU04, or
ELPLL08. After auto adjustment, the movement range for lens shift is reduced.
1. Press the Menu button.
2. Select the Extended menu and press Enter.
3. Select the Multi-Projection setting and press Enter.
To Next Page
Loading...
