Epson Pro L20002UNL - Connecting to an SDI Video Source

36
2. Connect the VGA connector to the Computer In port on the projector.
3. Tighten the screws on the VGA connector.
If your image colors appear incorrect, you may need to change the Input Signal setting in the projector's
Signal menu.
Parent topic: Connecting to Video Sources
Related references
Input Signal Settings - Signal Menu
Connecting to an SDI Video Source
If your video source has an SDI port, you can connect it to the projector using an optional BNC video
cable.
1. Connect the BNC video cable to your video source's SDI output port.
2. Connect the other end to the projector's SDI In port.
Note: Select the signal for the SDI In port in the SDI Settings in the Extended menu.
Parent topic: Connecting to Video Sources