32
Parent topic: Projector Placement
Related references
Projector Parts - Side/Rear
Protecting the Built-in Camera
If you use the projector near other devices that emit laser beams, install the protective plate over the
built-in camera to protect it from interference.
Remove the protective plate from its storage area on the side of the projector and place it over the built-
in camera on the front of the projector. When you finish, remove the protective plate from the camera
and return it to its storage area.
Parent topic: Projector Placement
Related references
Projector Parts - Front/Top
Projection Distance
The distance at which you place the projector from the screen determines the approximate size of the
image. The image size increases the farther the projector is from the screen, but can vary depending on
the zoom factor, aspect ratio, and other settings.
Use the tables here to determine approximately how far to place the projector from the screen based on
the installed lens and the size of the projected image. (Conversion figures may have been rounded up or
down.)
To Next Page
Loading...
