251
On/Standby
(power) light
Status
light
Laser
light
Temp light Filter
light
Status and solution
Off Flashing
blue
Orange Orange Off No lens installed, or lens shift or
supply voltage error. Remove and
reinstall the lens. If the problem
persists, turn off the projector, unplug
the power cord, and contact Epson
for help
Off Flashing
blue
Flashing
orange
Flashing
orange
Off Shutter error. Turn off the projector,
unplug the power cord, and contact
Epson for help.
Flashing blue Varies Varies Flashing
orange
Varies High temperature warning. If the
temperature gets too high, projection
will automatically stop.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Make sure the environmental
temperature is not too hot.
• Clean or replace the air filter.
Varies Varies Varies Varies Flashing
orange
Clean the air filter.
Flashing blue Varies Flashing
orange
Varies Varies Laser warning. Turn off the projector,
unplug the power cord, and contact
Epson for help.
Flashing blue Varies Flashing
orange
Varies Varies An unsupported lens is attached.
Attach only a supported lens.
Flashing blue Varies Flashing
orange
Flashing
orange
Varies Shutter error. Turn off the projector,
unplug the power cord, and contact
Epson for help.
To Next Page
Loading...
