46
9. Replace the lens cover as shown.
10. Tighten the screw to secure the lens cover to the projector.
11. Do one of the following:
• If you attach a lens that is different from the previous lens, you see a message to calibrate the lens
the next time you turn on the projector. Select Yes to calibrate the lens.
• If you remove and attach the same lens, press and hold the Default button on the remote control
for at least 3 seconds or select Lens Calibration in the Extended menu to calibrate the lens.
Lens calibration takes up to 3 minutes to complete. When calibration is finished, the lens returns to
its previous position.
Caution: If you see a message that lens calibration failed, turn off the projector, unplug the power
cord, remove the lens, and reinstall it. If you continue to see an error message, contact Epson.
To Next Page
Loading...
