72
Note: If you set Standby Mode to Communication On, you can use a web browser to select settings
and control projection even if the projector is in standby mode.
1. Make sure the projector is turned on.
2. Start your web browser on a computer or device connected to the network.
3. Type the projector's IP address into the browser's address box and press the computer's Enter key.
Note: You may need to log in to access some of the options on the Web Control screen. If you see a
log in window, enter your user name and password. (The default user name is EPSONWEB and the
default password is admin.)
You see the Epson Web Control screen.
1 Select Basic Control to control the projector remotely.
2 Select Test Pattern to display a test pattern
3 Select Crestron Connected to open the menu (if you enabled Crestron Connected in the
Network > Others menu)
4 Select Advanced to open the advanced menu screen.
5 Select Status Information to view the projector's status.
6 Select Remote Camera Access to take an image capture of the displayed image from a
remote location
To Next Page
Loading...
