Epson Stylus 1500 - Front; Rear PE Sensor Removal

Front / Rear PE Sensor Removal
1. Remove the upper housing. (See page 3-7.)
2. Remove the printer mechanism. (See page 3-9.)
3. Disconnect the sensor cables from the sensor connectors.
4. Remove the sensors from the rear paper guide assembly. (Release the hooks on both sides of
the sensors by inserting a screwdriver between the sensors and the rear paper guide assembly
as shown in the figure below.)
Rear Paper Guide Assembly
Rear PE Sensor Cable
Front PE Sensor Cable
Hooks
Rear PE Sensor Cable
Front PE Sensor Cable
Figure 3-30. Removing the Front / Rear PE Sensors
Disassembly and Assembly
EPSON Stylus 1500 Service Manual 3-33