Epson Stylus 1500 - Paper Eject Drive Unit Removal

Paper Eject Drive Unit Removal
1. Remove the printer mechanism. (See page 3-9.)
2. Remove the carriage unit. (See 3-22.)
3. Remove the paper eject frame unit. (See page 3-24.)
4. Remove the base frame. (See page 3-26.)
5. Remove the left paper eject assembly stopper, and move the left and right paper eject
assemblies to the notches on the right side of the paper eject drive unit. Then remove the
assemblies by pulling them forward.
6. Turn the paper feed roller unit clockwise with the knob, moving the trigger lever on the right
end of paper feed roller to set the hopper assembly to the lowest position. (The trigger lever is
shown in Figure 3-24.)
7.
Remove the (CBP 3 × 8) screw securing the paper eject drive unit to the left frame and then
remove the paper eject drive unit.
Eject Paper Assembly Stopper
Left Paper Eject Assembly
Right Paper Eject Assembly
CBP 3 x 8
Paper Eject Drive Unit
Hopper Assembly
Paper Feed Roller Unit
Trigger Lever
Notches
Pickup Roller Unit
Figure 3-24. Removing the Paper Eject Drive Unit
Disassembly and Assembly
EPSON Stylus 1500 Service Manual 3-27