Upper Housing Assembly Removal
1.1. Remove the knob, release lever, and ink cartridge cover from the printer. (Refer to Figure 3-4.)
2. Remove the rear sheet guide from the printer by pulling it toward the back. (See Figure 3-4.)
3. Remove the tractor unit from the printer mechanism. (Release the hooks from both sides of the
tractor by inserting tweezers between the tractor and mechanism, and pull up at the rear end
of tractor frame as shown in the figure below.)
4. Remove the control panel from the printer mechanism. (Release the tab by inserting a
screwdriver into the hole in the upper housing, as shown in the figure below.) Then,
disconnect the panel harness from the connector on the C172 MAIN board.
Tractor Unit
Tweezers
Tractor Unit Hook
Figure 3-2. Releasing the Tractor Hook
Control Panel
Tweezers
Upper Housing
Panel Harness
Figure 3-3. Removing the Control Panel
Disassembly and Assembly
EPSON Stylus 1500 Service Manual 3-7
To Next Page
Loading...
