Stylus 1500
Customer Data <********> 95/**/**
<< Menu 1 >> <<Menu 2>>
Head Data Writing --------------
----------------- --------------
Black Head Angle Adj. END
Uni-D Adj. Destination Data Writing only
Bi-D Adj. Initial Ink Charging
Color Head Angle Adj. Black - Color HV Adj.
Head Gap Adj.
--------------
Select : <Up> or <Down> Go : <SPACE> or <RETURN> Change menu : <1> or <2>
4. Move the cursor to the menu item “Destination Data Writing Only” to perform destination
data writing by pressing 1, 2, ↑ , and ↓ .
5. Immediately after you press the SPACE and ENTER keys , the main menu disappears briefly
and then reappears. When this happens, each parameter, such as destination, interface mode,
TOF value, economy/condensed, etc., is stored to the EEPROM.)
5. Choose END by selecting it from the keyboard. Choose another selection if you want to
continue in the adjustment mode.
6. The following menu appears on the display. If you want end the program, press 5.
Stylus 1500 <********> Customer Data <********> 95/**/**
( Customer Data Input ) .... 1
( Adjustment ) .... 2
( END ) .... 5
SELECT MENU
■
CAUTION
❒ The settings are not stored permanently in the EEPROM until the printer is turned off.
Turn off the printer immediately after adjustment.
❒ Reset protect counter B using the adjustment program to make the printer perform the
initial ink charge operation before sending the unit back to the customer.
7. Turn off the printer.
Adjustments
4-8 EPSON Stylus 1500 Service Manual
To Next Page
Loading...
