Epson Stylus Photo 1390 - Page 100

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 100
7. Remove the Extension Spring for the Driven Pulley Holder from the Main Frame
and the tab on the Drive Pulley Holder with needle-nose pliers.
Figure 4-64. Removing the Extension Spring for the Driven Pulley Holder
8. Slide the Driven Pulley Holder to the right end of the cutout on the Main Frame,
then remove it toward you.
Figure 4-65. Removing the Driven Pulley Holder
9. Remove the CR Drive Belt from the CR Motor Pinion Gear.
Figure 4-66. Removing the CR Drive Belt
10. Remove the four C.B.S. (P4) 3x6 screws that secure the CR Guide plate, and
remove it from the Main Frame.
Figure 4-67. Removing the CR Guide Plate
Tabs
Extension Spring for the
Driven Pulley Holder
Driven Pulley Holder
Driven Pulley Holder
 Align the positioning holes of the CR Guide Plate with the seven
tabs on the Main Frame. See Figure 4-67.
 Tighten the screws in the order shown in Figure 4-67.
CR Drive Belt
CR Motor Pinion Gear
4
3
2
1
8) C.B.S. (P4) 3x6
(8±1 kgf.cm)
8) C.B.S. (P4) 3x6
(8±1 kgf.cm)
CR Guide Plate
Tabs