Epson Stylus Photo 1390 - Page 99

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 99
5. Remove the foot of Right PG Torsion Spring from Tab A, and release the coil
section from Tab B to remove the Right PG Torsion Spring from the Main Frame.
Figure 4-61. Removing the Right PG Torsion Spring
6. Remove CR Shaft Mounting Plate Fixed Spring from the tab and cutout on the
Main Frame, and draw out the spring in the direction of the arrow.
Figure 4-63. Removing the CR Shaft Mounting Plate Fixed Spring
Place the feet of Left PG Torsion Spring and Right PG Torsion
Spring on the Carriage Shaft.
Figure 4-62. Installing the PG Torsion Springs
Right PG Torsion Spring
Tab A
Tab B
Foot
Left Side
Foot
Right Side
Insert the foot of CR Shaft Mounting Plate Fixed Spring into the
cutout of the Main Frame (rear side). See Figure 4-63.
Cutout (rear side)
Tab
CR Shaft Mounting Plate Fixed Spring
Cutout