Epson Stylus Photo 1390 - Page 104

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 104
20. Turn the Belt Holder Mounting Plate in the direction of the arrow, and remove it
from the Carriage Unit.
Figure 4-80. Removing the Belt Holder (1)
21. Remove the Belt Holder from the Carriage unit.
Figure 4-81. Removing the Belt Holder (2)
22. Release the CR Encoder Board Holder from the three tabs to remove it from the
Carriage Unit.
Figure 4-82. Removing the CR Encoder Board Holder
23. Disconnect the Sensor FFC from the CR Encoder Board, pull out the Sensor FFC
from the Carriage Unit, and remove the Carriage Unit.
Figure 4-83. Removing the Carriage Unit
Belt Holder Mounting Plate
Belt Holder
CR Encoder Board Holder
Tabs
CR Encoder Board
Sensor FFC