EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 106
4.2.6.7 Paper EJ Frame Assy
1. Remove the Printer Mechanism. See section 4.2.1.5 on page 82.
2. Remove the CD-R Unit Housing from the CD/DVD Tray Base by releasing the
Housing from two attaching points to the Tray Base.
3. Remove the Left Frame Support Plate. See Step 2 in Section 4.2.6.5 on page 98.
4. Put back the rotation position of the Right PG Cam.
5. Remove the four C.B.S. 3x6 screws and two C.B.P. 3x8 screws that secure the
Paper EJ Frame Assy.
Figure 4-85. Screws that Secure the Paper EJ Frame Assy
6. Remove the two Guide Pins on the CD/DVD Tray Base from the Left and Right
CD-R Release Lever Sub Assys.
7. Pull the Star Wheel Roller toward you, and remove the Paper EJ Frame Assy from
the Printer Mechanism while keeping the Assy from coming in contact with the
Right CD-R Release Lever Sub Assy and the tab on the Right CD-R Cover.
Figure 4-86. Removing the Paper EJ Frame Assy
C H E C K
P O I N T
See "4.3.2 Paper EJ Frame Assy" on page 129 to remove the Paper
EJ Frame Assy of Stylus Photo 1390.
Attaching Points
2
3
Tabs
2) C.B.S. 3x6
(8±1 kgf.cm)
4) C.B.P. 3x8
(6±1 kgf.cm)
4
1
Tabs
CD/DVD Tray Base
CD-R Unit Housing
Paper EJ Frame Assy
C A U T I O N
When performing the following procedure, take care not to scratch
the Star Wheel.
Point of contact
Star Wheel Roller
Left CD-R Release
Lever Sub Assy
Right CD-R Release
Lever Sub Assy
Guide
pins
Right CD-R
Cover
To Next Page
Loading...
