Epson Stylus Photo 1390 - Page 109

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 109
6. Remove Spur Gear 68 from the Paper EJ Roller Shaft.
Figure 4-93. Removing the Spur Gear 68
7. Remove the C.B.P. 3x6 screw that secures the Left CD-R Release Lever Sub Assy.
8. Push the small tab of the Left CD-R Release Lever Sub Assy with a flat-blade
screwdriver, and remove the Left CD-R Release Lever Sub Assy upwards from the
Main Frame.
Figure 4-94. Removing the Left CD-R Release Lever Sub Assy
Spur Gear 68
9) C.B.P. 3x6
(6±1 kgf.cm)
Tabs
Small Tab
 Make sure that the Left CD-R Release Lever Sub Assy is
correctly assembled as shown in the figure below.
Figure 4-95. Reinstalling the Left CD-R Release Lever Sub Assy (1)
 Align the Shaft and Bushing.
Figure 4-96. Removing the Left CD-R Release Lever Sub Assy (2)
 Align the two tabs on the Left CD-R Release Lever Sub Assy
with the positioning holes on the Main Frame. See Figure 4-94.