EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 110
4.2.6.9 Ink System Unit
1. For Stylus Photo 1400/1410:
Remove the Right CD-R Release Lever Sub Assy.
See section 4.2.6.8 on page 107.
For Stylus Photo 1390:
Remove the Printer Mechanism. See section 4.2.1.5 on page 82.
Remove the Paper EJ Frame Assy. See section 4.2.6.7 on page 106.
2. Release the Carriage lock, and move the Carriage Unit to the center.
See section 4.2.1.3 on page 79.
3. Remove the C.B.S. 3x8 screw that secures the Earth Cable to remove the Earth
Cables, and untie the Earth Cable from the Relay Connector Cable.
4. Disconnect the Pump Motor Connector from the Relay Connector.
Figure 4-97. Disconnecting the Pump Motor Connector
5. Remove the two C.B.S. 3x4 screws that secure the Ink System Guide Plate, and
remove it.
Figure 4-98. Removing the Ink System Guide Plate
Be sure to screw the two Earth Cables together.
Referring to Figure 4-97, correctly route the Relay Connector
Cable.
5) C.B.S. 3x8
(8±1 kgf.cm)
Relay Connector
Earth Cable
Relay Connector Cable
Align the cutout on the Ink System Guide Plate with the cutout
on the Main Frame.
Figure 4-99. Installing the Ink System Guide Plate
Tighten the screws in the order shown in Figure 4-98.
1
2
10) C.B.S. 3x4
(8±1 kgf.cm)
Ink System Guide
Plate
To Next Page
Loading...
