Epson Stylus Photo 1390 - Page 111

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 111
6. Remove the two C.B.S. 3x6 screws that secure the Ink System Unit.
Figure 4-100. Screws that Secure the Ink System Unit
7. Remove the two C.B.S. 3x6 screws that secure the Right Support Frame, and
remove the Right Support Frame from the Main Frame.
Figure 4-101. Removing the Right Support Frame
Tighten the screws in the order shown in Figure 4-100.
2
Rear
1
Front
2) C.B.S. 3x6
(8±1 kgf.cm)
 Align the positioning holes on the Right Support Frame with
the Guide Pins on the Main Frame.
Figure 4-102. Installing the Support Frame (Right)
 Tighten the screws in the order shown in Figure 4-101.
2
Upper
surface
2) C.B.S. 3x6
(8±1 kgf.cm)
1
2) C.B.S. 3x6
(8±1 kgf.cm)
Right Support
Frame
Positioning Holes and
Guide Pins