Epson Stylus Photo 1390 - 4.2.6.10 Release Holder Assy

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 113
4.2.6.10 Release Holder Assy
1. Remove the ASF Assy. See Section 4.2.4 on page 86.
2. Release the PE Sensor Connector Cable from the five tabs on the Release Holder
Assy.
3. Remove the three C.B.S. 3x6 screws that secure the Release Holder Assy.
4. Remove the three lower tabs of the Release Holder Assy from the Main Frame
with a flat-blade screwdriver, and remove the Release Holder Assy upwards.
Figure 4-107. Removing the Release Holder Assy
2) C.B.S. 3x6
(8±1 kgf.cm)
1
2
3
PE Sensor Connector CableTabs
Release Holder Assy
Rear side
Upper Tabs
Lower Tabs
Front side
 Align the three Upper tabs on the Release Holder Assy with the
positioning holes on the Main Frame. See Figure 4-107.
 Fit the FLAG Release Shaft by the Bushings on the Release
Holder Assy.
Figure 4-108. Reinstalling the Release Holder Assy
 Tighten the screws in the order shown in Figure 4-107.
Bushings
FLAG Release Shaft