Epson Stylus Photo 1390 - 4.2.6.11 FLAG Release Assy

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 114
4.2.6.11 FLAG Release Assy
1. Remove the APG Assy. See Section 4.2.6.4 on page 96.
2. Remove the Release Holder Assy. See Section 4.2.6.10 on page 113.
3. Remove the Guide Pin on the Driven Release Holder from the Main Frame using
tweezers, and slide the Driven Release Holder to the left as viewed from the front
of the Printer Mechanism.
4. Release the three tabs on the Driven Release Holder from the Main Frame, and
remove the FLAG Release Assy.
Figure 4-110. Removing the FLAG Release Assy
C A U T I O N
In the following procedure, the Parallel Pin 1.5 may drop off when
you slide the Driven Release Holder. Be careful not to lose the pin.
Figure 4-109. Parallel Pin 1.5
Parallel Pin 1.5
Guide Pin
Tabs
Front
Driven Release Holder
Rear
Guide pin
Tabs
Tab
Front
FLAG Release Assy