Epson Stylus Photo 1390 - 4.2.6.12 Upper Paper Guide Assys

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 115
4.2.6.12 Upper Paper Guide Assys
1. Remove the FLAG Release Assy. See Section 4.2.6.11 on page 114.
2. Remove the PE Sensor Holder. See Section 4.2.8.1 on page 124.
3. Pass a sheet of A3 size paper into the gap between the Upper Paper Guide Assy
and the Rear Paper Guide.
Figure 4-112. Setting the Paper
To avoid ink getting on the LD Roller, attach five Perforated Sheets
and the LD Cover Sheet to the six location shown in the figure
below.
 Remove the five Paper Guide Torsion Springs from the tabs,
insert the cutouts of the Perforated Sheets into the tabs to
attach them to the Main Frame, and then hook the Paper Guide
Torsion Springs onto the tabs again.
 Insert the LD Cover Sheet in between the frame so that the tabs
on the upper side of the LD Cover Sheet are visible from the
cutouts on the Main Frame, and attach the LD Cover Sheet.
Figure 4-111. Attaching the Perforated Sheets and the LD Cover
Sheet
LD Cover Sheet Perforated Sheets
Paper Guide
Torsion Spring
Tab Tab
A3-size paper
Rear Paper Guide