EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 117
4.2.6.13 Front Paper Guide and Paper Eject Roller
1. Remove the Paper EJ Frame Assy.
For Stylus Photo 1400/1410: See section 4.2.1.3 on page 79.
For Stylus Photo 1390: See section 4.3.1 on page 128.
2. Release the Carriage Lock, and move the Carriage Unit to the center.
See section 4.2.1.3 on page 79.
3. Remove the EJ Grounding Spring from the Main Frame with tweezers.
Figure 4-116. Removing the EJ Grounding Spring
4. Remove the Spacer from the EJ Roller Shaft.
5. Remove the Guide Pins on Left Bushing 8 from the Main Frame using tweezers,
and turn Left Bushing 8 toward you to align with the cutouts on the Main Frame.
Figure 4-118. Removing the Spacer and Rotating the Left Bushing 8
Referring to Figure 4-117, correctly install the EJ Grounding
Spring.
Figure 4-117. Installing the EJ Grounding Spring
EJ Grounding
Spring
Insert the Spacer into the groove on the Front Paper Eject Roller.
Guide
pin
Spacer
Groove
Left Bushing 8
Cutout
To Next Page
Loading...
