EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 125
4.2.8.2 PW Sensor
1. Remove the Carriage Unit. See section 4.2.6.5 on page 98.
2. Remove the C.P.B. (P1) 1.7x5 screw that secures the PW Sensor Holder, and
remove the PW Sensor Holder from the Carriage Unit.
Figure 4-140. Removing the PW Sensor Holder
3. Disconnect the FFC from the PW Sensor, and remove the PW Sensor.
Figure 4-141. Removing the PW Sensor
12) C.P.B. (P1) 1.7x5
(0.8±0.2 kgf.cm)
PW Sensor Holder
Carriage Unit Bottom
PW sensor
Connector
Make sure that the FFC is routed as shown in Figure 4-141.
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the PW Sensor, the following
adjustment must be performed.
PW Sensor Adjustment (p.133)
Refer to Chapter 5 “Adjustment” for details on the adjustments.
To Next Page
Loading...
