Epson Stylus Photo 1390 - Page 152

EPSON Stylus Photo 1390/1400/1410 Revision B
MAINTENANCE Overview 152
Figure 6-4. Lubrication (3)
Figure 6-5. Lubrication (4)
Figure 6-6. Lubrication (5)
Figure 6-7. Lubrication (6)
<Lubrication Point>
Contact points of the Main Frame and the
CR Scale Mounting Plate (Left/Right)
<Lubrication Type>
G-26
<Lubrication Amount>
A little at 4 points
<Remarks>
Apply with a brush.
<Lubrication Point>
Bushings of the Left and Right PG Cams
(inner circumference)
<Lubrication Type>
G-26
<Lubrication Amount>
1mm diameter of the inner circumference
<Remarks>
• Apply with a brush.
• Be careful not to attach the grease to
the PF scale.
Left Side
Right Side
Left Side Right Side
<Lubrication Point>
Contact point of the Left and Right PG
Torsion Springs and the Carriage Shaft.
<Lubrication Type>
G-26
<Lubrication Amount>
φ1mm x 2mm x 2 points
<Remarks>
Apply with a syringe.
(Pin Head:
φ1mm)
<Lubrication Point>
Contact point of the rear side of CR
Guide Plate and the slider of the Carriage
Unit
<Lubrication Type>
G-71
<Lubrication Amount>
70 ± 15mg x 3 times
<Remarks>
• Apply with a brush.
• Follow the application direction and
order shown on the left.
Right PG Torsion Spring
Right Side
Left PG Torsion Spring
Left Side
Rear side of CR Guide Plate
1
2
3