EPSON Stylus Photo 1390/1400/1410 Revision B
MAINTENANCE Overview 154
Figure 6-13. Lubrication (12)
6.1.4.1 Lubrication of Carriage Shaft
1. Fit the Carriage Unit to the Carriage Shaft, and move it to the center of the Shaft.
2. Using a syringe, lubricate the 2 holes at both ends of the Carriage Unit rear side
with the grease.
Figure 6-14. Carriage Shaft lubrication (1)
<Lubrication Point>
1. Contact points of the Rear Paper
Guide and the PF Roller
2. Contact point of the PF Grounding
Spring and the PF Roller
<Lubrication Type>
G-45
<Lubrication Amount>
1. Apply evenly.
2.
φ1mm x 2mm
<Remarks>
1. Apply with a brush.
2. Apply with a syringe.
(Pin Head:
φ1mm)
1
1
2
PF Roller
Rear Paper GuidePF Grounding Spring
C A U T I O N
In the following step, do not bring the needle of a syringe into
contact with the Carriage Shaft.
Lubrication Type Lubrication Amount
G-71 140 ± 10mg x 2 points
Carriage Unit
Carriage Shaft
Holes
To Next Page
Loading...
