Epson Stylus Photo 1390 - Page 47

EPSON Stylus Photo 1390/1400/1410 Revision B
TROUBLESHOOTING Overview 47
Note *: Stylus Photo 1390 does not have the CD/DVD-related units.
The Paper button
was pressed at the
setting of the CD/
DVD Tray.*
The CD/DVD Tray moves
toward the ASF and the back end
of it reaches to the Driven Roller
on the Upper Paper Guide.Then
the CD/DVD Tray tries to go
farther, but it is ejected.
PW sensor 1. Check that the PW Sensor FFC is placed in the specified routing
positions and it does not make contact with any parts.
1. Place the PW Sensor FFC in the specified
routing positions.
2. Check that the PW Sensor FFC is connected to the CR Encoder
Board and PW Sensor Connector. Refer to the above photo.
2. Connect the FFC to the CR Encoder Board and
PW Sensor Connector.
3. Check the PW Sensor or PW Sensor FFC for damages. 3. Replace the PW Sensor with a new one.
Table 3-4. Troubleshooting of Paper Out Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
PW Sensor
Connector
FFC
CR Encoder Board
Connector