Epson Stylus Photo 1390 - Page 46

EPSON Stylus Photo 1390/1400/1410 Revision B
TROUBLESHOOTING Overview 46
The Paper button
was pressed at the
setting of the CD/
DVD Tray.*
The CD/DVD Tray HP detection
sequence stops and the Tray is
ejected.
CD/DVD Tray 1. Check the HP detection position or white markings of the CD/
DVD Tray for paper dust and foreign matter.
1. Remove paper dust and/or foreign matter from
the detection position.
2. Check the Driven Roller surface for contamination such as paper
dust and CD-R coating material.
2. Feed A4-size sheets of plain paper from the
ASF Assy several times to remove the
contamination.
3. Check that the HP detection position or white markings of the
CD/DVD Tray are not chipped.
3. Replace the CD/DVD Tray with a new one.
The CD/DVD Tray is fed toward
the ASF Assy, but is ejected
immediately.
PW sensor 1. Check the PW Sensor for contamination such as paper dust,
ink, etc.
1. Clean the PW Sensor surface.
2. Compare the EEPROM values in two places and check that they
are not approximated to each other.
2. Replace the PW Sensor with a new one.
Table 3-4. Troubleshooting of Paper Out Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
White Markings
HP detection
position
PW sensor
Carriage Unit Bottom