Epson Stylus Photo 1390 - Page 87

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 87
9. Remove the two C.B.S. 3x6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Figure 4-31. Removing the Guide Roller LD
 Referring to Figure 4-28, route each of the Cables and FFCs.
 After routing the APG Motor Cable to the rib of the ASF Assy,
secure it with the Acetate Tape 2 as shown below.
Figure 4-29. Installing the Acetate Tape 2
 When installing the FFC to the connector (CN15), secure it with
acetate tape as shown below.
Figure 4-30. Installing the Acetate Tape
5mm
Acetate Tape 2
APG Motor Cable
3mm
FFC
CN15
Acetate Tape
Align the Guide Pins and tabs on the Guide Roller LDs with the
positioning holes on the Main Frame. See Figure 4-31.
2) C.B.S. 3x6
(8±1 kgf.cm)
Front
Face
Guide Pin
Tab
LD Roller Shaft
Guide Roller LD
Guide Roller LD