Epson Stylus Photo 1390 - Page 88

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 88
11. Remove the three C.B.S. (P4) 3x8 screws that secure the ASF Assy, and remove
the ASF Assy from the Printer Mechanism.
Figure 4-32. Removing the ASF Assy
2
1
6) C.B.S. (P4) 3x8
(8±1 kgf.cm)
ASF Assy
6) C.B.S. (P4) 3x8
(8±1 kgf.cm)
34
 Align the Guide Pin and four tabs on the ASF Assy with the
positioning holes on the Main Frame so that there is no gap
between the ASF Assy and the Main Frame.
Figure 4-33. Installing the ASF Assy
 Tighten the screws in the order shown in Figure 4-32.
Tab
Guide Pin
Tab
Tab
Tab