Epson Stylus Photo 895 - CR Unit Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 102
4.2.15 CR unit removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1 "Housing
Removal")
2. Remove the CR timing belt from the CR pinion gear. (Refer to Section 4.2.5 "CR
motor removal")
3. Release the Printhead FFC from the cable holders on the LD roller shaft holder.
And disconnect the Printhead FFC from the connectors CN8 and CN9 on the Main
board
Figure 4-54. Taking Printhead FFC off
4. Remove the Lever, PG’s hook from the installation hole in the right side of the
frame, then remove the Lever, PG.
Figure 4-55. Removal of lever and PG