Epson Stylus Photo 895 - Housing Lower Cover Removal; Housing Lower Cover Left Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 78
4.2.3 Housing Lower Cover Removal
There are two housing lower covers on the right and left sides of a printer.
4.2.3.1 Housing Lower Cover Left Removal
1. Remove the housing from the printer. (Refer to Section 4.2.1 "Housing Removal")
2. Remove two screws (C.B.S. 3x6, F/ZN and C.B.P. 3x8, F/ZN) and detach the Sub
Left Panel Housing from the printer mechanism. (Detach the stacker at the same
time)
Figure 4-10. Sub Left Panel Removal
3. Remove three screws (C.B.P. 3x8, F/ZN) from the left housing lower cover and
detach the cover.
Figure 4-11. Housing Lower Cover Left Removal
 Tightening torque for screw
• C.B.S 3x6 F/ZN screw for Sub Panel Housing on the printer side:
9 +/- 1 kgf.cm
• C.B.P 3x8 F/ZN screw for Sub Panel Housing on the lower cover side:
6 +/- 1 kgf.cm
C.B.P 3x8 F/ZN
C.B.S 3x6 F/ZN
 Tightening torque for screw
• C.B.P 3x8 , F/ZN three screws for housing lower cover : 6 +/- 1 kgf.cm
C.B.P 3x8 F/ZN
C.B.P 3x8 F/ZN