Epson Stylus Photo 895 - Operation Panel Removal; Printer Panel Board Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 75
4.2.2 Operation Panel removal
The panel board equipped with printer is as follows:

Printer panel board: C408PNL-B

Monochrome panel board: C408PNL
4.2.2.1 Printer Panel Board Removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1 "Housing
Removal")
2. Remove 3 screws (C.B.S 3x6 F/ZN and C.B.P 3x8 F/ZN) securing the Operation
Panel Assembly. Then, remove the Operation Panel Assembly from the Printer
Mechanism.
Figure 4-7. Removing 3 screws for Operation Panel
 Tightening Torque for Screw
• C.B.S 3x6 F/ZN screw for ground screw on the housing: 3.5 +/- 1 kgf.cm

To install the housing, make sure to install the FFC and the
Earth of monochrome panel.
Monochrome panel earth
C.B.S 3x6 F/ZN
C.B.P 3x8 F/ZN