EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 74
Figure 4-5. Removing the right side housing
4. Remove the FFC of housing monochrome panel board.
Figure 4-6. Housing FFC removal
C A U T I O N
Tightening Torque for screw
• C.B.S-TITE 3x6 F/ZN screw for housing front side: 6 +/- 1kgf.cm
• C.B.S 3x6 F/ZN screw for housing back side : 6+/- 1kgf.cm
Ensure that C.B.S-TITE 3 x 6 F/ZN screws are used for the two
screws on the front side of the printer. The tips of these screws
are rounded for user’s safety.
To detach the housing, pay attention since the monochrome
panel FFC is installed.
FFC connector
To Next Page
Loading...
