Epson Stylus Photo 895 - Monochrome Panel Board Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 77
4.2.2.2 Monochrome panel board removal
1. Remove the housing. (Refer to Section 4.2.1 "Housing Removal")
2. Remove four screws (C.B.P. 3x8, F/ZN) and detach the monochrome panel board.
3. Remove two screws (C.B.S. 3x6, F/ZN) located on the rear of the monochrome
panel board and detach the panel shield plate.
Figure 4-9. Monochrome panel board
4. Remove the FFC from the monochrome panel board connector.
C A U T I O N
 Pay attention since the buttons of monochrome panel will be not
fixed anymore if the monochrome panel board is detached.
C.B.P 3x8 F/ZN
 Tightening torque for screw
• C.B.S 3x6, F/ZN screw for monochrome panel board: 6 +/- 1 kgf.cm
• C.B.P 3x8, F/ZN screw for panel shield plate: 6 +/- 1 kgf.cm