Epson Stylus Photo 895 - Page 76

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 76
3. Disconnect the Panel FFC from the connector on the C408PNL-B board
4. Remove two screws (C.B.P. 3x8, F/ZN) and detach the Sub Right Panel Housing
from the printer panel board (C408PNL-B).
Figure 4-8. Removing 2 screws for C408PNL board
5. Remove the Panel Shield Plate and the C408PNL-B board from the Operation
Panel Assembly.
 Tightening torque for screw
• C.B.S 3x6 F/ZN screw for control panel cover: 9 +/- 1 kgf.cm
C.B.P 3x8 F/ZN screw for control panel cover: 6 +/- 1 kgf.cm
C.B.P 3x8 F/ZN
 Tightening torque for screw
• C.B.P 3x8, F/ZN screw for printer panel board: 6 +/- 1 kgf.cm
C H E C K
P O I N T

Removing the Operation Panel Assembly also separates the
stacker assembly from the Printer Mechanism, since the Stacker
Assembly is held with Operation Panel.