Epson Stylus Photo 895 - Preview Monitor Disassembly Procedure; Back Case Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Preview monitor disassembly procedure 111
4.3 Preview monitor disassembly procedure
This section indicates a disassembling procedure of optional preview monitor.
4.3.1 Back case removal
1. Remove the tilt screws and then tilt stand.
Figure 4-72. Tilt base removal
2. Remove two screws securing the monitor cable cover and detach the monitor cable
cover.
Figure 4-73. Monitor cable cover removal
3. Remove the monitor cable from the hook on the rear case.
Figure 4-74. Monitor cable hook removal
4. Remove four screws securing the back case.
Figure 4-75. Removal of the back case attaching screws
Tilt stand
Tilt screw
Screws
Monitor cable cover
Hook
Screws