Epson Stylus Photo 895 - Outline; Adjustment Items

EPSON Stylus PHOTO 895/785EPX Revision A
Adjustment Outline 115
5.1 Outline
This section provides explanations on the adjustments required after dismantling and
reassembling this product.
5.1.1 Adjustment items
The items for adjustment are listed below. Ensure that all instructions related to these
adjustment items are implemented without fail to ensure trouble-free operations of this
product when performing the adjustments described below.
NOTE: The circle (O) indicated that adjustments must be carried out. The
numbers inside the circles indicate the adjustment sequence.
NOTE: The following adjustment procedure is not required with this product.
• Head leaning adjustments
This section explains the detailed procedures for adjustment programs.
In order to ensure stable printing functions and maintain quality between each printer
mechanism, it is necessary to set up the adjustment information for each mechanism.
It is therefore necessary to set up and save the correct mechanism information with the
use of the adjustment program when the printer mechanisms, the main circuit board,
and the printer head have been replaced.
Table 5-1. Adjustment items
1 2 3 4 5 6 7 8
Service item
Parallel
adjustments
EEPROM
initial
setting
Head ID
input
Ink
Change
Bi-D
Adjustment
USB ID
input
Memory
card drive
confirmation
Protection
Counter
reset
Printhead
removal
NA NA NA NA
c
NA NA NA
Printhead
replacement
NA NA
c d e
NA NA NA
Main board
replacement
NA
cd
NA
efg
NA
CR Unit
replacement
or removal
c
NA NA NA
d
NA NA NA
CR Motor
replacement
NA NA NA NA
c
NA NA NA
Printer
mechanism
replacement
NA NA
c d e
NA NA NA
Waste Ink pad
replacement
NA NA NA NA NA NA NA
c
C A U T I O N
Make sure the power supply to the printer has been switched off
when removing parts or assembling parts during adjustment
program execution.