Epson Stylus Photo 895 - ASF Motor Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 97
4.2.12 ASF Motor Removal
1. Remove the housing from the printer. (Refer to Section 4.2.1 "Housing Removal")
2. Remove the panel unit from the printer. (Refer to Section 4.2.2 "Operation Panel
removal")
3. Remove the printer mechanism from the printer. (Refer to Section 4.2.7 "Printer
mechanism removal")
4. Remove three nuts (M3 hexagon nut) securing the ASF motor to the ink system
frame.
Figure 4-45. Removing of ASF motor
5. Disconnect the ASF motor's connector cable from the CN11 on C408 Main board.
6. Remove the ASF motor from the ink system frame.
Hexagon Nut M3
C A U T I O N
 Pay attention not to damage gears when attaching the ink system
unit.
 Connect the ASF motor connector cable to the CN11 on C408
Main board. It is recommended to use tweezers or small pliers
since the CN11 is not located near the rear end of Main board.
 Tightening torque for screw
• M3 hexagon nut for ASF motor: 6 +/- 1 kgf.cm