EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 73
4.2.1 Housing Removal
1. Remove the two (C.B.S-TITE 3x6, F/ZN) screws fixing the left and right panel
covers to the housing from the holes in the bottom of the printer (the screws are
situated near to the rear.)
Figure 4-2. Removing two screws for housing
2. Remove three screws (C.B.S. 3x6, F/ZN) from the rear of the printer.
Figure 4-3. Removing three screws for housing
3. Release hooks inside the left and right panels. The housing can be detached by
pushing it forward to the operator.
Figure 4-4. Removing the left side housing
C.B.S-TITE 3x6 F/ZN
C.B.S 3x6 F/ZN
To Next Page
Loading...
