Epson Stylus Photo 895 - LD Roller Removal

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 88
4.2.9 LD Roller removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1 "Housing
Removal")
2. Take the Head FFC off from the Head FFC holder located along the LD roller
shaft holder.
Figure 4-26. Taking Head FFC out from the FFC holder
3. Remove two screws (C.B.S 3x6 F/ZN) securing the LD roller holder to the Main
frame.
Figure 4-27. Removing two screws securing the LD roller holder
LD roller shaft holder
Head FFC holder
 Tightening Torque for screw
• C.B.S 3x6, F/ZN screw for screw securing the LD roller holder: 9 +/- 1 kgf.cm
• C.B.S 3x8, F/ZN screw for screw securing the LD roller holder: 9 +/- 1 kgf.cm
C.B.S 3x6, F/ZN
C.B.S 3x8, F/ZN
LD roller cover
LD roller holder reinforcement board