Epson Stylus Photo 895 - Page 89

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 89
4. Push the two hooks of the LD roller shaft holder as shown in the following figure.
5. Pull the LD roller shaft holder unit upward from the Main frame.
Figure 4-28. Pushing two hooks of the LD roller shaft holder
6. Remove the LD roller along with the Clutch mechanism from the LD roller shaft
holder unit.
Figure 4-29. Removing the LD roller with Clutch mechanism
Two hooks for LD roller holder
Clutch mechanism
LD Roller
LD Roller shaft holder unit
Panel shield plate