Epson Stylus Photo 895 - Page 106

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 106
8. Lift up the left edge of the Front paper guide while slanting the Front paper guide
by pulling up its front edge, and then slide the Front paper guide to the left side
after releasing the right hook on the Front paper guide
Figure 4-62. Remove the Front paper guide
9. Fit the protrusions of the Left PF roller bushing to the notches in the frames as
shown in the following figure and remove the PF roller fasten spacer with tweezer
Figure 4-63.
Fit the protrusions of the Left PF roller bushing to each notches
10. As shown in Step 2 in the above figure, slide the left roller bushing to the right
side.
Step1
Step1
Step2
Paper Guide Front
PF Roller Fasten Spacer
Left PF Roller Bushing
1
1
2