Epson Stylus Photo 895 - Page 60

EPSON Stylus PHOTO 895/785EPX Revision A
Troubleshooting Troubleshooting with LED Error Indications 60
5
When the paper is
loaded from the ASF
and ejected without any
printing. After eject the
paper, paper eject
sequence is continued.
1. Check if the CN4
connector cable for PE
sensor cable is
disconnected on the
Main board or sensor.
2. Check if the PE sensor
operates correctly by
using the tester. Refer
to Table 3-2 "Sensor
Check Point".
1. Connect the CN4
connector cable to the
CN4 on the Main board.
2. Replace the PE sensor
with new one.
3. If the problem is not
solved, replace the Main
board with new one.
Table 3-8. No Ink Cartridge or Ink Out error indication
Step
No.
Detail phenomenon Check point Remedy
1
A [No Ink Cartridge] or
[Ink Out Error] message
is displayed when the
power to the printer is
switched on.
1. Check to ascertain that
an ink cartridge has
been set in place.
2. Check the remaining
ink with the printer
driver or STM3.
3. Check to ascertain that
the head FFC is been
attached correctly to the
head.
4. Check if the head FFC
has any damaged.
5. Check if the I/C works
correctly.
1. Set the ink cartridge in
place.
2. Remove and then reset the
ink cartridge in place.
3. Connect the Head FFC.
4. Replace the Head FFC.
5. Replace the ink cartridge
(faulty CSIC.)
6. If the problem is not
solved, replace the Main
board with new one.
Table 3-7. Paper jam error indication
Step
No.
Detail phenomenon Check point Remedy
Table 3-9. Multiple papers are always loaded
Step
No.
Detail phenomenon Check point Remedy
1
Any error indication is
not displayed on the
monitor. But, multiple
papers are always
loaded from ASF.
Check if the Paper return
plate is operating correctly
in the ASF when the paper
is loaded.
• Assemble the torsion
spring 25.7 in the ASF
frame.
Table 3-10. Paper is always loaded without any print job
Step
No.
Detail phenomenon Check point Remedy
1
Paper is always loaded
from ASF without any
print job.
ASF hopper continue to
flapping when the
printer is turned on.
1. Check if the tip of the
Change lever has any
damage.
2. Check if the
Compression spring
2.94 comes off from the
Change lever.
1. Replace the Change lever
with new one.
2. Set the Compression
spring 2.94 in the Change
lever.
Torsion spring 25.7
Change lever
comp. spring 2.94