Epson Stylus Photo 895 - Page 86

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 86
7. Remove the following screws securing each circuit board to the Shield plate. Refer
to Figure 4-23. "Panel shield plate removal".
8. Remove two screws (C.F.S-TITE 3x8, F/ZN) for the AC120V cable and one screw
(C.B.(O) 4x5, F/ZG) for the ground cable.
Figure 4-23. Panel shield plate removal
Figure 4-24. Remove the screw securing each circuit board

C408 MAIN: Remove nine screws.
C.B.S 3x6 F/ZN (Red/Green circled screws): 7pcs (for Main board)
C.P. 3x6 F/ZN (Yellow circled screws): 2pcs (USB interface connector,
preview monitor connector)

C408 PSE: Remove five screws.
C.B.S 3x6 F/ZN (Blue/Green circled screws): 5pcs (for PSE board)
C.B.S 3x6 F/ZN
C.B.S 3x6 F/ZN
C.P 3x6 F/ZN
C408 PSE Board
C.B.S 3x6 F/ZN
6
7
3
4
1
2
12
11
5
10
9
8
C408 MAIN Board