Epson Stylus Photo 895 - Page 91

EPSON Stylus PHOTO 895/785EPX Revision A
Disassembly and Assembly Disassembly 91
2. Assemble the LD roller shaft holder unit while storing the Paper
return plate into the ASF frame
Figure 4-33. LD Roller shaft holder assembling procedure (2)
3. Make sure the PE detection lever is the same as the following
figure.
Figure 4-34. Correct position of the PE detection lever
Paper return plate
PE detection lever
 Fasten the LD roller shaft holder with two screws (C.B.S 3x6
F/ZN) in the order indicated in the following figure.
Figure 4-35. Fastening the LD roller shaft holder

Tightening torque for screw
• C.B.S 3x6 F/ZN screw for LD roller shaft holder unit: 9+/1 kgf.cm
1
2